Directed Electronics Automate 210D Instructions d'exploitation télécharger pdf (Page 24)

Turning the Display On and Off (Standby Mode)

Press the e key (31) to turn the display on or off.

Self-Test

After the balance has been turned on, an automatic

self-test of the balance’s electronic circuitry

is performed, and the draft shield closes automatically.

When a zero readout is displayed, the balance

is ready for operation.

Automatic Warmup of the Balance Electronics in

MC 210 S, MC 210 P and MC 410 S (-0CE), MC 21S

Once you have connected the balance to AC power

and turned on the power, the balance’s electronics

automatically begin to warmup. The timer for

warmup is set to 4 minutes. The remaining warmup

time in minutes and seconds is displayed in

a countdown mode.

When the remaining time displayed is less

than one minute, you can interrupt this warmup

procedure by pressing the e key to turn the

balance off and back on again. Following

the self-test and display of a zero readout,

the balance is ready to operate again.

After 4 minutes have elapsed, the balance displays

a zero readout and is then ready to operate.

* = including the Signatories of the Agreement on

the European Economic Area

Important Note Concerning Verified Balances

Approved for Use as Legal Measuring Instruments

in the E.U.*

For verified balances that have a verification

scale interval “e” which is greater than the scale

interval “d,” and a scale interval “d” ≥0.1mg,

the last digit on the display is bordered.

1–20

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 187 188

Pas de commentaire

Directed Electronics Automate 210D Instructions d'exploitation Page 24