Directed Electronics Automate 210D Instructions d'exploitation télécharger pdf (Page 153)

Activating a Data Output Process

You can define the data output parameter so that output is activated either

automatically, or when a print command is received. You have two options for the

automatic mode: data output can be either synchronous with the balance display

or activated at defined intervals (to select the parameter, see part 2, “Utilities”).

Data Output by Print Command

The print command can be transmitted by a software command or by pressing the

print key.

You can connect an external universal switch for remote control to the balance

interface port in addition to an interface cable for a different device. For the switch,

use pins 8 and15 of this port and a cable up to1.5 m or 5 ft. long.

If data output is requested by a software command (see the section on “Data Input

Formats”), you can install a15 m (50 ft.) cable for RS-232C or a 300 m (984 ft.)

cable for RS-423.

Automatic Data Output

In the “auto print” operating mode, the data are output to the interface port without

requiring a print command. You can choose to have data output automatically at

defined print intervals with or without the stability parameter. Whichever parameter

you choose, the data will be output as the readouts appear on the balance display.

If you select the auto print setting, data will be transmitted immediately the moment

you turn on the balance. Automatic data output can be stopped and restarted

either when you press the print key, or when an external print command is received,

if you have set menu code 6 2 1.

These data output functions are described in part 2, “Utilities.”

4–15

1 2 ... 148 149 150 151 152 153 154 155 156 157 158 ... 187 188

Pas de commentaire

Directed Electronics Automate 210D Instructions d'exploitation Page 153