Directed Electronics Automate 552 Manuel d'utilisateur télécharger pdf (Page 15)

1999 Directed Electronics, Inc. Vista, CA 15

This wire supplies a 200 mA (-) output that can be used to honk the vehicle horn. It outputs a single pulse when

locking the doors with the remote, and two pulses when unlocking with the remote. This wire will also output

pulses for 30 seconds when the Panic Mode is activated. If the vehicle has a (+) horn circuit, an optional relay

can be used to interface with the system, as shown below.

Before connecting this wire, remove the supplied fuse. Connect to the battery positive terminal or the constant

12V supply to the ignition switch as described in the Finding the Wires You Need section of this guide.

NOTE: Always use a fuse within 12 inches of the point you obtain (+)12V. Do not use the 10A fuse

in the harness for this purpose. This fuse is intended to protect the module.

When the system receives the code controlling Channel 2, for longer than 1.5 seconds, the RED/WHITE wire will

supply an output as long as the transmission continues. This is often used to operate a trunk/hatch release or

other relay-driven function. This output can also be programmed to provide the following types of output: Instant

validity, latched, latched-reset with ignition, 30-second timed, or second unlock output. (See Features Description

section of this guide for details.)

IMPORTANT! Never use this wire to drive anything except a relay or low-current input! The transis-

torized output can only supply 200 mA of current. Connecting directly to a solenoid, motor, or other

high-current device will cause it to fail.

H1/12 RED/WHITE Channel 2, 200 mA (-) output

H1/11 RED (+)12V constant power input

H1/10 BROWN (-) horn honk output

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 41 42

Pas de commentaire

Directed Electronics Automate 552 Manuel d'utilisateur Page 15