Directed Electronics Automate 552 Manuel d'utilisateur télécharger pdf (Page 18)

This wire sends a negative pulse every time the remote start is activated. This can be used to pulse the disarm

wire of the vehicle's factory anti-theft device. Use a relay to send a (-) or (+) pulse to the disarm wire as shown

in the diagrams below. This wire can also be used as a special accessory output. (See Feature Descriptions section

of this guide.)

Relay for Negative (-) Disarm Wire Relay for Positive (+) Disarm Wire

remote start harness (H3)

This output is programmable. If programmed for status output, the wire will supply an output at all times the

remote start is operating. If programmed for factory security rearm, the wire will supply a pulse whenever the

remote start times out or is shut down using the transmitter.

This output provides a 200mA as soon as the remote starter is activated. It can be used to power a relay to ener-

gize a positive (+) third ignition as shown below. This output is capable of driving two relays if necessary.

H3/2 BLUE/BLACK (-) optional third ignition output

H3/1 BLUE status/factory security rearm output

H2/2 LIGHT GREEN/BLACK (-) auxiliary output

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 41 42

Pas de commentaire

Directed Electronics Automate 552 Manuel d'utilisateur Page 18