Directed Electronics AutoCommand 28624TN Guide d'installation télécharger pdf (Page 16)

Once the lower dash panel has been removed, locate the ignition

harness at the back of the key cylinder. This is usually a group of

heavy gauge wires (approximate 14ga.).

Place the black lead of the LED tester to a clean metal surface in

the kick panel area and secure it. Probe one of the thicker gauge

wires. The ignition wire colors of your specific vehicle can be

obtained at www.autocommand.com.

Testing for Constant Power Wires

WARNING! Before making any connection to constant

battery power make sure that the two 30 amp fuses

are removed from the fuse holders on the two pink 12

VOLT wires. Failure to do so may cause fire or short-

ing of sensitive electrical components.

note! More problems are attributed to poor ground

connections than any other cause. Take extra care

to ensure the ground is a clean metal-to-metal

contact and secure.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 78 79

Pas de commentaire

Directed Electronics AutoCommand 28624TN Guide d'installation Page 16