Directed Electronics S 580 E Guide de l'utilisateur télécharger pdf (Page 44)

38 Operation

3.13 System Shutdown

Routine shutdown may vary depending on your particular requirements. However, it is recommended that

you incorporate the following procedures into your production shutdown routine.

3.13.1 Production Shutdown

To shut down at the end of a production shift:

1. Wait for the dispensing program to complete and verify that all motion has stopped.

2. Unload all workpieces.

3. If necessary, purge or remove and clean the dispensing valve as instructed in the

applicable valve manual.

4. Exit FmXP.

5. Exit Windows XP and turn off the computer.

 Make sure Windows XP completely shuts down before turning off the computer.

6. Turn the main power circuit breaker on the back of the system to the OFF (0) position.

WARNING! CAUTION!

Before performing any servicing or parts replacement, the system must be shut

down for service. Failure to do so could cause serious injury to the user and/or

serious damage to the dispensing system.

3.13.2 Service Shutdown

To shut down for service:

1. Perform a production shutdown. See 3.13.1 Production Shutdown.

2. Disconnect the main power cable and place it in a locked box.

3. Disconnect the facility air hose and place a warning tag on the main air inlet.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 63 64

Pas de commentaire

Modèles	Type de document
AU-A300	Spécifications CYP AU-A300 Specifications, 24 pages Spécifications CYP AU-A300 Specifications, 16 pages
AU-D160	Manuel de l'utilisateur AU-D160, 28 pages
CH-514TXL	Manuel de l'utilisateur CH-514TXL/RXL - HY, 16 pages
QU-DP14	Spécifications CYP QU-DP14 Specifications, 12 pages

Directed Electronics S 580 E Guide de l'utilisateur Page 44