Directed Electronics S 580 E Guide de l'utilisateur télécharger pdf (Page 40)

34 Operation

3.11 Setting the Heaters

The only available Heater in the dispensing system is the needle heater. Heater temperature is set in the

FmXP software. The heater controller monitors the Resistance Temperature Detector (RTD), compares it

to the heat parameters set in Fluidmove, and regulates the voltage going to the heating element to

maintain the set temperature.

3.11.1 Needle Heater

CAUTION! The operator can turn the heaters ON and OFF and monitor their function.

However, only authorized personnel should set heater parameters.

 NOTE Contact your applications engineer or Nordson ASYMTEK Technical Support for

information about setting heater parameters for your particular application.

To setup the needle heater in Fluidmove:

1. In the Fluidmove Main Window, click on Run a Program .

2. In the Production Window (Figure 3-14), click on Setup and in the list box select

Setup Heater 1.

Figure 3-14 Fluidmove Production Window

 The Heater Control Window (Figure 3-15) opens.

3. In the Heater Control Window, locate the channel (loop) for the desired heater.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 63 64

Pas de commentaire

Directed Electronics S 580 E Guide de l'utilisateur Page 40