Directed Electronics VS102 Guide de l'utilisateur télécharger pdf (Page 21)

Chapter 2: Installation

attaching the cable end to the port on the V102 (see “Connecting the

power/data cable” on page 17).

Flush mounting the V102

1. Photocopy the section of the V102 that contains the four mounting

holes for use as a template to plan the mounting hole locations.

Make sure the photocopy is scaled one to one with the

mounting holes on the bottom of the V102.

2. Mark the mounting hole centers on the mounting surface.

3. Place the V102 over the marks to ensure the planned hole centers

align with the true hole centers (adjusting as necessary).

4. Use a center punch to mark the hole centers.

5. Drill the mounting holes with a 9 mm bit appropriate for the surface.

6. Place the V102 over the mounting holes and insert the mounting

screws through the bottom of the mounting surface and into the

V102.

When installing the V102, hand tighten only. Damage

resulting from overtightening is not covered by the warranty.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 59 60

Pas de commentaire

Directed Electronics VS102 Guide de l'utilisateur Page 21