Directed Electronics Valet 561T Guide d'installation télécharger pdf (Page 23)

2233

iinntteerrnnaall pprrooggrraammmmiinngg jjuummppeerr

This jumper is used to determine the light flash output. In the (+) position, the on-board relay is enabled and

the unit will output (+)12V on the H1/11 WHITE wire. In the (-) position, the on-board relay is disabled. The

H1/11 WHITE wire will supply a (-) 200 mA output suitable for driving factory parking light relays. To access the

jumper, open the control module.

NNOOTTEE::

For parking light circuits that draw 10 amps or more, the internal jumper must be switched

to a (-) light flash output. P/N

88661177

or a standard automotive SPDT relay must be used on the

H1/11 light flash output harness wire.

lliigghhtt ffllaasshh jjuummppeerr

NOTE: JUMPER IS

INSIDE THE CASE

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 33 34

Pas de commentaire

Directed Electronics Valet 561T Guide d'installation Page 23