Directed Electronics Automate 210D Guide d'installation télécharger pdf (Page 20)

step 9

Optional connections (channel 2, 3)

When the system receives the code controlling channel 2, for

longer than 1.5 seconds, the RED/WHITE wire (H1/12-

channel 2) will supply an output as long as the transmission

continues. This is often used to operate a trunk/hatch release or

other relay-driven function.

When the system recieves the code controlling channel 3, the

output is instantaneous, and the WHITE/BLUE wire (H1/3-

channel 3) will supply an output as long as the transmission

continues. This is used to operate an accessory function.

iimmppoorrttaanntt::

Never use these wires to drive anything but a

relay or a low-current input! The transistorized output

can only supply 200 mA of current. Connecting directly

to a solenoid, motor, or other high-current device will

cause it to fail.

➜

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 54 55

Pas de commentaire

Directed Electronics Automate 210D Guide d'installation Page 20