Directed Electronics 2 Guide d'installation télécharger pdf (Page 6)

H1/10 YELLOW (+) 12V ignition input: The H1/10 YELLOW wire must be connected to the true (+)12V ignition

wire of the vehicle, whether the 516L is being interfaced with a security system or a remote start system.

H1/11 BLACK (-) chassis ground input: Remove any paint and connect this wire to bare metal, preferably with

a factory bolt rather than your own screw. (Screws tend to either strip or loosen with time.) We recommend

grounding all your components, including the siren, to the same point in the vehicle.

H1/12 RED (+) constant power input: Connect this wire to the positive battery terminal or to the constant 12V

supply to the ignition switch.

NOTE: Always use a fuse within 12 inches of the point you obtain (+)12V.

remote start input harness (H2), 2-pin connector

This harness and its connections are only required when wiring the 516L to a remote start system. The remote

start input harness plugs into the red 2-pin socket on the control module. When interfaced with a remote start

system, the 516L detects various remote start states by monitoring the H1/10 YELLOW, H2/1 ORANGE/BLACK, and H2/2

BLUE/BLACK wires, and in different combinations of wire activation, the 516L emits the appropriate voice message.

______

BLUE/BLACK (-) STATUS/SECOND IGNITION INPUT (OPTIONAL)

ORANGE/BLACK (-) ACCESSORY INPUT (OPTIONAL)

H2/1

H2/2

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

Pas de commentaire

Directed Electronics 2 Guide d'installation Page 6