Directed Electronics Viper ESP 540 Guide d'installation télécharger pdf (Page 12)

Deciding on component location

Control module

Never put the control module in the engine compartment!

The first step in hot-wiring a vehicle is removing the driver's side under-

dash panel to access the starter and ignition wires. If the control module

is placed just behind the driver's side dash it can easily be disconnect-

ed.

When locating the control module, try to find a secure location that will

not require you to extend the harnesses’ wires (they are 1.5 meters

long). Keep it away from the heater core (or any other heat sources) and

any obvious leaks.

Some good control module locations: Above the glove box, inside the

center console, above the underdash fuse box, behind or below above

the radio, etc.

N3001L_2009-04print.qxd 5/12/2009 11:14 AM Page 6

25-Mar-10

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 177 178

Pas de commentaire

Directed Electronics Viper ESP 540 Guide d'installation Page 12