Directed Electronics AutoCommand 25522 Manuel d'installation Page 5

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 24
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 4
5
©
2005 Directed Electronics, Inc.
!! WARNING !!
On cars with airbags, you may notice bright yellow tubes or harnesses under-
neath the steering column area. DO NOT tamper with these wires in any way,
so as to prevent personal injury and/or damage to the air bag system.
Battery gases are explosive. Do not smoke while working near the cars bat-
tery.
!!CAUTION!!
When working the wires through the cars firewall, be sure to protect them
from sharp metal edges and from hot surfaces on the engine.
Note: Some installers connect a battery charger to the vehicle’s battery dur-
ing installation. This is fine, but it must be removed before running the vehicle
under AutoCommand
®
control.
INSTALLATION INSTRUCTIONS
1. Before You Start
Take the time to read through the whole installation manual.
Wire Harnesses: Before installation, always check that your wire
harness matches the list/drawing on page 4 of the manual.
IMPORTANT: After having read the entire manual, start the
installation by putting the yellow WARNING STICKER in the engine com-
partment. Choose a surface that is clean and readily visible when the hood is
open.
Vue de la page 4
1 2 3 4 5 6 7 8 9 10 ... 23 24

Commentaires sur ces manuels

Pas de commentaire