Directed-electronics Ready Remote Manuel d'utilisateur télécharger pdf (Page 24)

step 4

Safety Shutdown Wires

With all ignition wires properly connected, find the appropriate

safety shutdown wires. These are the brake wire and hood pin wires.

First locate the factory brake wire using your test probe. Find the

switch at the top of the metal arm coming off the brake pedal.

There are usually two wires connected to that switch. Locate the

warning! These wires are meant to protect

the vehicle and anyone near the vehicle.

They

mmuusstt

be connected appropriately to

prevent damage to the vehicle and possible

bodily injury. Failure to properly install

these wires may cause the vehicle to lunge if

remote started while in gear.

➜

87A

+12 VDC CONSTANT (FUSED 20A)

GROUND

TO 2

STARTER

VIOLET (+) OUTPUT

TO STARTER

STARTER RELAY

(NOT PROVIDED)

87A

+12 VDC CONSTANT (FUSED 20A)

GROUND

TO STARTER

STARTER RELAY

(NOT PROVIDED)

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 69 70

Pas de commentaire

Directed-electronics Ready Remote Manuel d'utilisateur Page 24