Directed-electronics 2.2 Manuel d'utilisateur télécharger pdf (Page 23)

At anytime during the next 10 seconds, press and

release the Valet switch. Now the Status LED lights

constantly if you have entered Valet® Mode, and

go out if you have exited Valet Mode.

To enter or exit Valet mode with the remote control:

Press

A U X

two times, and then

A U X

to put the system into/out of Valet

Mode.

Note:

The LED on the control center turns on solid when in Valet Mode

and shuts off when exiting Valet Mode.

➤ Remote feature programming

The remote control has a menu for conﬁguring user features. Before you

start make sure the keypad is unlocked. (See page 13)

To program the remote user features:

Press and hold the 1.

A U X

button on the remote for 12 seconds. (ig-

nore the car indicator at 3 seconds). The remote emits one long

beep, and the trasmit LED turns on to indicate the Main Menu.

Press and hold the 2.

A U X

button for 1. 5 seconds: The remote beeps

two-tmes. You are now in the Remote Conﬁguration menu.

To configure the remote control features:

Press, and then release the command button. The remote beeps to 1.

indicate the feature conﬁguration.

Press the 2.

A U X

button to access the Auto keypad lock feature.

Press the 3.

A U X

button to change the Auto keypad lock feature.

When the remote beeps once the keypad automatically locks •

6o seconds after the last button operation to avoid accidental

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 51 52

Pas de commentaire

Directed-electronics 2.2 Manuel d'utilisateur Page 23