Directed Electronics Matrix 1 Guide d'installation télécharger pdf (Page 16)

Programming Jumper

Light Flash Jumper

This jumper is used to determine the light flash output. In the (+) position,

the on-board relay is enabled and the unit will output (+)12V on the WHITE

wire, H1/2. In the (-) position, the on-board relay is disabled. The WHITE

wire, H1/2, will supply a 200 mA (-) output suitable for driving factory

parking light relays.

NOTE: For parking light circuits that draw 10 amps or more, the jumper must

be switched to a (-) light flash output. P/N 8617 or a standard automotive

SPDT relay must be used on the H1/2 light flash output harness wire.

Important! DO NOT connect the H1/2 light flash wire to

a negative vehicle light flash wire before changing the

programming jumper to the negative polarity position or

damage to vehicle light circuit may occur.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 39 40

Pas de commentaire

Directed Electronics Matrix 1 Guide d'installation Page 16