Directed-electronics 5 Manuel d'utilisateur télécharger pdf (Page 14)

3. After the last digit continue to hold for

three seconds.

The LED status indicator will light steadily if you are entering Valet

Mode and will turn off if you are exiting Valet Mode.

To exit Valet Mode:

1. Turn the ignition on.

2. Within 10-seconds press once.

transmitter valet mode

The operations described in this section refer to transmitter buttons.

Remember, the buttons used in all the instructions in this guide corre-

spond to a Standard Configuration transmitter. This may not be how

your transmitter is set up.

To enter Valet Mode, press and simultaneously. The LED

status indicator will light solid if you are entering Valet Mode, or will

turn off if you are exiting Valet Mode.

nnoottee::

The pin code can be entered after turning the ignition On and the press

and hold the blank key on the PlainView 2 Valet switch for one second.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 36 37

Pas de commentaire

Directed-electronics 5 Manuel d'utilisateur Page 14