Directed Electronics 4-button series Manuel d'utilisateur télécharger pdf (Page 2)

The 519H 3-Channel Receiver uses a computer-based EEPROM Learn Routine to assign individual functions to be

controlled by the remote transmitter buttons. The system uses a rolling code, Venom XR receiver to provide

improved range and greater security. The receiver Learn Routine can also be used to program up to twelve of

Directed’s rolling code transmitters. Additionally, the receiver will store the programmed transmitters in non-

volatile memory, so that if power is lost and then reconnected, the system can recall the transmitter codes from

memory. Once initial programming is completed, no additional programming should be required.

Once the unit has been powered up, the system can be programmed using the two program buttons on top

of the receiver. If you will only be using the Channel One output, it will not be necessary to program the

other outputs.

TToo PPrrooggrraamm CChhaannnneell OOnnee

1. Press and hold Program Button One on the receiver.

2. The LED will start flashing in groups of one.

3. While continuing to hold Program Button One, press the transmitter button that you want to control

Channel One.

4. The LED will light steadily when the code has been learned.

PPrrooggrraammmmiinngg tthhee SSyysstteemm

PPrroodduucctt DDeessccrriippttiioonn

1 2 3 4 5 6

Pas de commentaire

Directed Electronics 4-button series Manuel d'utilisateur Page 2